Table of Contents
Advertisement
DCS-G900 User's Manual
To run the Setup Wizard, click on: Start > Programs > D-Link Setup Wizard.
Your camera's IP Address will
be displayed here along with its
corresponding MAC Address.
Click Wizard
You must change the Admin ID and Password
immediately to protect your camera against
unauthorized access. By default, the Admin ID
and Password are blank. To change the Admin
ID and Password, select both Change boxes and
enter a New ID and New Password.
Click Next
Enter an IP Address and Subnet Mask for
your camera if you want to change the current
settings. Enter your Gateway and DNS settings.
These settings must correspond with your
network settings for you to access the camera.
If you are unsure of what these settings should
be, check with your network administrator.
Click Next
D-Link Systems, Inc.
The DCS-G900 Setup Wizard
14
Advertisement
Table of Contents
