Table of Contents
Advertisement
manual OPeraTIOn
Your SOLO
Air Cleaner has the ability to work separately
2
from your computer. Turn the SOLO
cable from SOLO
, and unplug the Power Adapter from the
2
wall. You may now move the SOLO
home or office.
NOTE: When using the touch panel on the front of the
SOLO
, you must use your fingertips to operate the controls.
2
Finger nails, pens, pencils, etc will not work to activate or
control the unit.
On / Off air flow Control
To turn your SOLO
unit on, press the up and down touch
2
pads on the unit simultaneously. Figure 5. Once on, press
the up or down arrow pads to adjust the fan speed. To turn
your SOLO
unit back off, press the up and down touch pads
2
simultaneously again.
Touch
sensitive
areas
figure 5.
©2010 Hunter Fan Co.
off, unplug your USB
2
to anywhere in your
2
6
aIr Cleaner maInTenanCe
Cleaning
Proper maintenance of your Hunter Air Cleaner will help
ensure years of trouble free service. Follow these steps to
properly maintain your air purifier:
1. Approximately every 90 days, the outside of the unit
should be cleaned with a soft, damp cloth.
2. Follow the instructions for Changing the Filter on this
page to determine when and how to replace the filter.
NOTES:
• The air cleaner must be unplugged from your computer
and the power outlet during the cleaning process.
• Be sure the unit is completely dry before plugging it in and
using.
• Never immerse the SOLO
2
to clean.
Changing the filter
1. To change the filter in your SOLO
unplug the power cord, and USB cable.
2. Turn the SOLO
on it's side and remove the wire base
2
from the bottom of the unit by compressing the hinges on
either side of the wire base (a) and gently pulling each
out of the bottom of the SOLO
a. Pinch
in water or use harsh chemicals
, turn the unit off,
2
unit (b). Figure 6.
2
b. Pull to remove
figure 6.
43051-01 20100609
Advertisement
Table of Contents
