ASROCK X58 EXTREME6 - V1 User Manual page 40

IEEE 1394 Header
(9-pin FRONT_1394)
(see p.12 No. 27)
Serial port Header
(9-pin COM1)
(see p.12 No. 31)
HDMI_SPDIF Header
(2-pin HDMI_SPDIF1)
(see p.12 No. 34)
The Installation Guide of Front USB 3.0 Panel The Installation Guide of Front USB 3.0 Panel
The Installation Guide of Front USB 3.0 Panel The Installation Guide of Front USB 3.0 Panel The Installation Guide of Front USB 3.0 Panel
Step 1
Intall the Front USB 3.0 Panel into the 3.5"
drive bay of the chassis.
Step 3
Plug the Front USB 3.0 cable into the USB 3.0
header (USB3_1_2) on the motherboard.
Besides one default IEEE 1394
RXTPAM_0
GND port on the I/O panel, there is one
RXTPBM_0
+12V
IEEE 1394 header
GND
(FRONT_1394) on this
1
+12V
motherboard. This IEEE 1394
RXTPBP_0
GND
header can support one IEEE
RXTPAP_0
1394 port.
This COM1 header supports a
RRXD1
DDTR#1
DDSR#1
serial port module.
CCTS#1
1
RRI#1
RRTS#1
GND
TTXD1
DDCD#1
HDMI_SPDIF header, providing
SPDIF audio output to HDMI VGA
1
GND
card, allows the system to
SPDIFOUT
connect HDMI Digital TV/
projector/LCD devices. Please
connect the HDMI_SPDIF
connector of HDMI VGA card to
this header.
Step 2
Step 4
4 0 4 0 4 0
4 0 4 0
Screw the Front USB 3.0 Panel to the
drive bay.
The Front USB 3.0 Panel is ready to use.