Connectors - ASROCK PE PRO User Manual

Jumper
PS2_USB_PWR1
(see p.6/p.7/p.8 item 22)
Note: To select +5VSB, it requires 2 Amp and higher standby current.
CLRCMOS1
(see p.6/p.7/p.8 item 17)

2.8 Connectors

2.8 Connectors
2.8 Connectors 2.8 Connectors 2.8 Connectors
Connectors are NOT jumpers. DO NOT place jumper caps over
these connectors.
Connector
FDD connector
(33-pin FLOPPY1)
(see p.6/p.7/p.8 item 10)
Note: Match the red marking on the floppy ribbon cable with Pin1.
Primary IDE connector (Blue)
(39-pin IDE1)
(see p.6/p.7/p.8 item 7)
IDE1
PIN1
Connect to the motherboard
Note: To optimize compatibility and performance, please connect your hard
disk drive to the primary IDE connector (IDE1, blue) and CD-ROM to the
secondary IDE connector (IDE2, black).
Setting
2 3
1 2
+5V +5VSB
solder points
Figure
FLOPPY1
Pin1
Secondary IDE connector (Black)
(39-pin IDE2)
(see p.6/p.7/p.8 item 8)
PIN1
Blue
80-Pin ATA 100/133 cable
Description
Short pin2, pin3 to enable
+5VSB (standby) for PS/2 or
USB wake up events.
Disconnect the power cord,
then short the solder points
to clear CMOS by using
metal material, e.g., a paper
clip.
Description
Red marking
IDE2
Black
Connect to the IDE devices
1 3 1 3 1 3
1 3 1 3