Installation Of Memory Modules (Dimm); Installing A Dimm - ASROCK N68-GS3 UCC Installation Manual

2.3 Installation of Memory Modules (DIMM)

2.3 Installation of Memory Modules (DIMM) 2.3 Installation of Memory Modules (DIMM)
2.3 Installation of Memory Modules (DIMM) 2.3 Installation of Memory Modules (DIMM)
N68-GS3 UCC / N68-S3 UCC motherboard provides two 240-pin DDR3 (Double
Data Rate 3) DIMM slots, and supports Dual Channel Memory Technology. For dual
channel configuration, you always need to install two identical (the same brand,
speed, size and chip-type) memory modules in the DDR3 DIMM slots to activate Dual
Channel Memory Technology. Otherwise, it will operate at single channel mode.
1. It is not allowed to install a DDR or DDR2 memory module into
DDR3 slot;otherwise, this motherboard and DIMM may be damaged.
2. If you install only one memory module or two non-identical memory
modules, it is unable to activate the Dual Channel Memory Technology.

Installing a DIMM

Installing a DIMM
Installing a DIMM Installing a DIMM Installing a DIMM
Please make sure to disconnect power supply before adding or
removing DIMMs or the system components.
Step 1. Unlock a DIMM slot by pressing the retaining clips outward.
Step 2. Align a DIMM on the slot such that the notch on the DIMM matches the break
on the slot.
The DIMM only fits in one correct orientation. It will cause permanent
damage to the motherboard and the DIMM if you force the DIMM into the
slot at incorrect orientation.
Step 3. Firmly insert the DIMM into the slot until the retaining clips at both ends fully
snap back in place and the DIMM is properly seated.
ASRock N68-GS3 UCC / N68-S3 UCC Motherboard
1 1 1 1 1 1
1 1 1 1