Installing Windows 2000 / Windows Xp / Windows Xp 64-Bit With Raid Functions - ASROCK K8UPGRADE-NF3 Installation Manual

2.6 2.6 2.6 Serial AT T T T T A (SA Serial A Serial A A (SA A (SAT T T T T A) Hard Disks Installation A (SA
2.6 2.6 Serial A Serial A A (SA
This motherboard supports Serial ATA (SATA) hard disks and RAID functions. This
section will guide you to install the SATA hard disks.
STEP 1: Install the SATA hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard's SATA
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA hard disk.
2.7 2.7 2.7 Realtek Audio Driver Installation For Windows ME Realtek Audio Driver Installation For Windows ME Realtek Audio Driver Installation For Windows ME
2.7 2.7 Realtek Audio Driver Installation For Windows ME Realtek Audio Driver Installation For Windows ME
If your system is Windows ME, please make sure to install USB 2.0 driver before
installing Realtek Audio driver; for other driver installation, please follow the driver
order in our support CD.
2.8 2.8 2.8 2.8 2.8 Installing Windows 2000 / Windows XP / Installing Windows 2000 / Windows XP / Installing Windows 2000 / Windows XP / Installing Windows 2000 / Windows XP / Installing Windows 2000 / Windows XP /
Windows XP 64-bit With RAID Functions Windows XP 64-bit With RAID Functions Windows XP 64-bit With RAID Functions
Windows XP 64-bit With RAID Functions Windows XP 64-bit With RAID Functions
If you want to install Windows 2000, Windows XP or Windows XP 64-bit on your
SATA HDDs with RAID functions, please follow the below steps.
STEP 1: Make a SATA Driver Diskette.
A. Insert the ASRock Support CD into your optical drive to boot your system.
B. During POST at the beginning of system boot-up, press <F11> key, and
then a window for boot devices selection appears. Please select CD-
ROM as the boot device.
C. When you see the message on the screen, "Do you want to generate
Serial ATA driver diskette [YN]?", press <Y>.
D. Then you will see these messages,
Please insert a diskette into the floppy drive.
WARNING! Formatting the floppy diskette will
lose ALL data in it!
Start to format and copy files [YN]?
Please insert a floppy diskette into the floppy drive, and press <Y>.
E. The system will start to format the floppy diskette and copy SATA drivers
into the floppy diskette.
STEP 2: Set Up BIOS.
A. Enter BIOS SETUP UTILITY
B. Set the "SATA Operation Mode" option from [non-RAID] to [RAID].
STEP 3: Use "RAID BIOS Setting Utility" to set RAID configuration.
1 4 1 4 1 4
1 4 1 4
ASRock K8Upgrade-NF3 Motherboard
A) Hard Disks Installation A) Hard Disks Installation A) Hard Disks Installation
A) Hard Disks Installation
Advanced screen IDE Configuration.