Chipset Configuration - ASROCK K8 COMBO-Z User Manual

3.3.2 Chipset Configuration

Advanced
Chipset Settings
OnBoard AC97 Audio
OnBoard LAN
AGP Aperture Size
AGP Data Rate
AGP Fast Write
Primary Graphics Adapter
HT Width
HT Speed
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
OnBoard AC97 Audio
Select [Auto] or [Disabled] for the onboard AC97 Audio feature.
OnBoard LAN
This allows you to enable or disable the onboard LAN feature.
AGP Aperture Size
It refers to a section of the PCI memory address range used for graphics
memory. It is recommended to leave this field at the default value unless the
installed AGP card's specifications requires other sizes.
AGP Data Rate
For an AGP 3.0 card, you may set AGP Data Rate between [8X] or [4X], and
the default value is [8X]. For an AGP 2.0 card, you may set AGP Data Rate
among [4X], [2X], and [1X], and the default value is [4X].
AGP Fast Write
Use this item to enable or disable the feature of AGP fast write protocol
support.
Primary Graphics Adapter
This item will switch the PCI Bus scanning order while searching for video
card. It allows you to select the type of Primary VGA in case of multiple
video controllers.
HT Width
For 939-Pin CPU, you may set the HyperTransport width as [8 BIT], [16 BIT],
or [Auto]. For 754-Pin CPU, you may set the HyperTransport width as
[8 BIT] or [Auto]. The default value is [Auto].
HT Speed
You may set the HyperTransport speed as [Auto], [200 MHz], [400 MHz],
[600 MHz], [800 MHz], or [1000 MHz]. The default value is [Auto].
BIOS SETUP UTILITY
[Auto]
[Enabled]
[64 MB]
[8X]
[Disabled]
[PCI]
[Auto]
[Auto]
Enable/Disable onboard
Audio device.
Select Screen
Select Item
+ - Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit