Advanced Screen; Cpu Configuration - ASROCK A780GM-LE 128M - V1.0 User Manual

preparing an additional floppy diskette or other complicated flash utility.
Please be noted that the USB flash drive or hard drive must use FAT32/16/
12 file system. If you execute ASRock Instant Flash utility, the utility will
show the BIOS files and their respective information. Select the proper
BIOS file to update your BIOS, and reboot your system after BIOS update
process completes.
3.4 3.4 3.4

Advanced Screen

Advanced Screen Advanced Screen
3.4 3.4 Advanced Screen Advanced Screen
In this section, you may set the configurations for the following items: CPU
Configuration, Memory Configuration, Chipset Configuration, ACPI Configuration, IDE
Configuration, PCIPnP Configuration, Floppy Configuration, SuperIO Configuration,
and USB Configuration.
Main Smart Advanced
Advanced Settings
WARNING : Setting wrong values in below sections
may cause system to malfunction.

CPU Configuration

Memory Configuration
Chipset Configuration
ACPI Configuration
IDE Configuration
PCIPnP Configuration
Floppy Configuration
SuperIO Configuration
USB Configuration
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
Setting wrong values in this section may cause
the system to malfunction.
3.4.1 3.4.1 CPU Configuration CPU Configuration
3.4.1 3.4.1 CPU Configuration 3.4.1 CPU Configuration CPU Configuration
Advanced
CPU Configuration
AM2 Boost
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
Spread Spectrum
Boot Failure Guard
Cool' n' Quiet
Secure Virtual Machine
L3 Cache Allocation
Advanced Clock Calibration
Processor Maximum Frequency
Processor Maximum Voltage
Multiplier/Voltage Change
HT Bus Speed
HT Bus Width
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
BIOS SETUP UTILITY
H/W Monitor Boot Security
Options for CPU
Select Screen
Select Item
Enter Go to Sub Screen
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
BIOS SETUP UTILITY
If AUTO, multiplier and
[Disabled] voltage will be left at the
rated frequency/voltage. If
[Auto]
Manual, multiplier and
[200]
voltage will be set based
[100]
on User Selection in Setup.
[Auto]
[Enabled]
[Auto]
[Enabled]
[Auto]
Select Screen Select Screen
[Disabled]
Select Item Select Item
x15.0 3000 MHz
+- +- Change Option Change Option
1.400 V
F1 F1 General Help General Help
[Auto]
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
[Auto]
ESC ESC Exit Exit
[Auto]
4 1 4 1 4 1 4 1 4 1
Exit