Advanced Screen; Cpu Configuration - ASROCK A780GM-LE - V1.1 User Manual

3.4 3.4 3.4 3.4 3.4

Advanced Screen

Advanced Screen Advanced Screen Advanced Screen Advanced Screen
In this section, you may set the configurations for the following items: CPU
Configuration, Chipset Configuration, ACPI Configuration, IDE Configuration, PCIPnP
Configuration, Floppy Configuration, SuperIO Configuration, and USB Configuration.
Main Smart
Advanced Settings
WARNING : Setting wrong values in below sections
may cause system to malfunction.

CPU Configuration

Chipset Configuration
ACPI Configuration
IDE Configuration
PCIPnP Configuration
Floppy Configuration
SuperIO Configuration
USB Configuration
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
Setting wrong values in this section may cause
the system to malfunction.
3.4.1 3.4.1 CPU Configuration CPU Configuration
3.4.1 3.4.1 CPU Configuration 3.4.1 CPU Configuration CPU Configuration
Advanced
CPU Configuration
AM2 Boost
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
Spread Spectrum
Boot Failure Guard
Cool' n' Quiet
Secure Virtual Machine
L3 Cache Allocation
Processor Maximum Frequency
Processor Maximum Voltage
Multiplier/Voltage Change
Memory Clock
Flexibility Option
CAS Latency (CL)
TRCD
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
AM2 Boost
This option appears only when you adopt AM2 CPU. If you set this option to
[Enabled], you will enable ASRock AM2 Boost function, which will improve the
memory performance. The default value is [Disabled]. Please refer to cau-
tion 13 on page 9 for details.
Overclock Mode
Use this to select Overclock Mode. The default value is [Auto]. Configuration
options: [Auto], [CPU, PCIE, Sync.], [CPU, PCIE, Async.] and [Optimized].
BIOS SETUP UTILITY
Advanced H/W Monitor
BIOS SETUP UTILITY
[Disabled]
[Auto]
[200]
[100]
[Auto]
[Enabled]
[Auto]
[Enabled]
[BSP Only]
x15.0 3000 MHz
1.400 V
[Auto]
[Auto]
[Disabled]
[Auto]
[Auto]
Boot Security Exit
Options for CPU
Select Screen
Select Item
Enter Go to Sub Screen
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
If AUTO, multiplier and
voltage will be left at the
rated frequency/voltage. If
Manual, multiplier and
voltage will be set based
on User Selection in Setup.
Select Screen Select Screen
Select Item Select Item
+- +- Change Option Change Option
F1 F1 General Help General Help
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
4 1 4 1 4 1 4 1 4 1