Installing A Dimm; Expansion Slots - ASROCK 939DUAL-SATA2 Installation Manual

Hide thumbs Also See for 939DUAL-SATA2:

Table of Contents

Available languages

Installing a DIMM

Please make sure to disconnect power supply before adding or

removing DIMMs or the system components.

STEP 1:

Unlock a DIMM slot by pressing the retaining clips outward.

STEP 2:

Align a DIMM on the slot such that the notch on the DIMM matches the

break on the slot.

The DIMM only fits in one correct orientation. It will cause permanent

damage to the motherboard and the DIMM if you force the DIMM into the

slot at incorrect orientation.

STEP 3:

Firmly insert the DIMM into the slot until the retaining clips at both ends

fully snap back in place and the DIMM is properly seated.

2.3

(Future CPU Port, PCI Slots, PCIE Slots, and AGP Slot)

There are 1 Future CPU Port, 3 PCI slots, 2 PCIE slots, and 1 AGP slot on 939Dual-

SATA2 motherboard.

Future CPU Port (Yellow-Colored Port):

Future CPU Port allows you to upgrade your AMD 939-Pin CPU to AMD 940-Pin CPU by

installing an add-on ASRock M2CPU Board into this future CPU Port on 939Dual-

SATA2 motherboard. Before you upgrade the 939-Pin CPU to the 940-Pin (M2) CPU,

it is necessary to adjust the jumper settings for those required jumpers on 939Dual-

SATA2 motherboard. Please refer to the table below for the correct jumper settings.

ASRock 939Dual-SATA2 Motherboard

9 9 9 9 9

Table of Contents