Expansion Slots; Installing An Expansion Card - ASROCK 775XFIRE-ESATA2+ User Manual

Hide thumbs Also See for 775XFIRE-ESATA2+:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
The DIMM only fits in one correct orientation. It will cause permanent damage
to the motherboard and the DIMM if you force the DIMM into the slot at
incorrect orientation.
Step 3.
Firmly insert the DIMM into the slot until the retaining clips at both ends fully
snap back in place and the DIMM is properly seated.
2.4 Expansion Slots (PCI, PCI Express, and AGI Express
2.4 Expansion Slots (PCI, PCI Express, and AGI Express
2.4 Expansion Slots (PCI, PCI Express, and AGI Express
2.4 Expansion Slots (PCI, PCI Express, and AGI Express
2.4 Expansion Slots (PCI, PCI Express, and AGI Express
Slots)
Slots)
Slots)
Slots)
Slots)
There are 3 PCI slots, 2 PCI Express slots, and 1 AGI Express slot (PCI Express x4)
on this motherboard.
PCI slots: PCI slots are used to install expansion cards that have the 32-bit PCI
interface.
PCIE Slots: PCIE1 (PCIE x16 slot) is used for PCI Express cards with x16 lane
width graphics cards.
PCIE2 (PCIE x1 slot) is used for PCI Express cards, such as
Gigabit LAN card, SATA2 card, etc.
AGI Express slot (PCI Express x4):
AGI Express slot (PCI Express x4) is used to install PCI Express expan-
sion cards. For the information of the compatible PCI Express VGA cards,
please refer to the "Supported PCI Express VGA Card List for AGI Ex-
press Slot (PCI Express x4)" on page 9.

Installing an expansion card

Installing an expansion card
Installing an expansion card
Installing an expansion card
Installing an expansion card
Step 1.
Before installing the expansion card, please make sure that the power
supply is switched off or the power cord is unplugged. Please read the
documentation of the expansion card and make necessary hardware
settings for the card before you start the installation.
Step 2.
Remove the bracket facing the slot that you intend to use. Keep the screws
for later use.
Step 3.
Align the card connector with the slot and press firmly until the card is
completely seated on the slot.
Step 4.
Fasten the card to the chassis with screws.
ASRock 775XFire-eSATA2+ Motherboard
1 5
1 5
1 5
1 5
1 5

Advertisement

Table of Contents
loading

Table of Contents