Jumpers Setup - ASROCK 770ICAFE - ANNEXE 840 Manual

2.5 2.5 2.5

Jumpers Setup

Jumpers Setup Jumpers Setup
2.5 2.5 Jumpers Setup Jumpers Setup
The illustration shows how jumpers are setup.
When the jumper cap is placed on pins, the
jumper is "Short". If no jumper cap is placed on
pins, the jumper is "Open". The illustration
shows a 3-pin jumper whose pin1 and
pin2 are "Short" when jumper cap is placed on
these 2 pins.
Jumper
PS2_USB_PW1
(see p.2, No. 1)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
PS2_USB_PW2
(see p.2, No. 24)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
PS2_USB_PW3
(see p.2, No. 26)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
PS2_USB_PW4
(see p.2, No. 28)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
Clear CMOS Jumper
(CLRCMOS1)
(see p.2, No. 20)
Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS includes
system setup information such as system password, date, time, and system
setup parameters. To clear and reset the system parameters to default setup,
please turn off the computer and unplug the power cord from the power
1 4 1 4 1 4
1 4 1 4
Setting
Default Clear CMOS
ASRock 770iCafe Motherboard
Short Open
Short pin2, pin3 to enable
+5VSB (standby) for PS/2 or
USB wake up events.
Short pin2, pin3 to enable
+5VSB (standby) for
USB6_7 wake up events.
Short pin2, pin3 to enable
+5VSB (standby) for
USB8_9 wake up events.
Short pin2, pin3 to enable
+5VSB (standby) for
USB10_11 wake up events.