Installation; Hot Plug And Hot Swap Functions For Sata / Sataii Hdds - ASROCK 770DE3L User Manual

2.10 2.10 Serial A 2.10 Serial A Serial A Serial AT T T T T A (SA A (SA A (SAT T T T T A) / Serial A A (SA
2.10 2.10 Serial A A (SA

Installation

Installation Installation Installation Installation
This motherboard adopts AMD SB710 south bridge chipset that supports Serial
ATA (SATA) / Serial ATAII (SATAII) hard disks and RAID (RAID 0, RAID 1, RAID 10
and JBOD) functions. You may install SATA / SATAII hard disks on this
motherboard for internal storage devices. This section will guide you to install the
SATA / SATAII hard disks.
STEP 1: Install the SATA / SATAII hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA / SATAII hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard's SATAII
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA / SATAII hard
disk.
If you plan to use RAID 0 or RAID 1 function, you need to install at least 2
SATA / SATAII hard disks. If you plan to use RAID 10 function, you need to
install at least 4 SATA / SATAII hard disks.
2.11 Hot Plug and Hot Swap F 2.11 Hot Plug and Hot Swap F
2.11 Hot Plug and Hot Swap Functions for SA 2.11 Hot Plug and Hot Swap F 2.11 Hot Plug and Hot Swap F
HDDs HDDs HDDs HDDs HDDs
This motherboard supports Hot Plug and Hot Swap functions for SATA / SATAII
Devices in RAID / AHCI mode. AMD SB710 south bridge chipset provides hardware
support for Advanced Host controller Interface (AHCI), a new programming interface
for SATA host controllers developed thru a joint industry effort. AHCI also provides
usability enhancements such as Hot Plug.
NOTE
What is Hot Plug Function?
If the SATA / SATAII HDDs are NOT set for RAID configuration, it is called
"Hot Plug" for the action to insert and remove the SATA / SATAII HDDs
while the system is still power-on and in working condition.
However, please note that it cannot perform Hot Plug if the OS has been
installed into the SATA / SATAII HDD.
What is Hot Swap Function?
If SATA / SATAII HDDs are built as RAID 1 then it is called "Hot Swap" for
the action to insert and remove the SATA / SATAII HDDs while the system
is still power-on and in working condition.
A) / Serial AT T T T T AII (SA A) / Serial A A) / Serial A AII (SA AII (SAT T T T T AII) Hard Disks AII (SA
A) / Serial A AII (SA
unctions for SAT T T T T A / SA unctions for SA unctions for SA
unctions for SA
2 8 2 8 2 8 2 8 2 8
AII) Hard Disks AII) Hard Disks AII) Hard Disks
AII) Hard Disks
A / SA A / SAT T T T T AII A / SA AII AII
A / SA AII AII