Onboard Headers And Connectors - ASROCK 4CORE1600P35-WIFI Installation Manual

2.8 Onboard Headers and Connectors

2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 28 or p.3 No. 27)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2/3 No. 9)
connect the blue end
to the motherboard
Note: Please refer to the instruction of your IDE device vendor
Serial ATAII Connectors
(SATAII_1 (Port0):
see p.2/3, No. 12)
SATAII_5 (Port4)
(SATAII_2 (Port1):
see p.2/3, No. 14)
SATAII_6 (Port5)
(SATAII_3 (Port2):
see p.2/3, No. 17)
(SATAII_4 (Port3):
see p.2/3, No. 18)
(SATAII_5 (Port4):
see p.2/3, No. 11)
(SATAII_6 (Port5):
see p.2/3, No. 19)
SATAII_6 (Port5) connector can be used for internal storage device or
be connected to eSATAII connector to support eSATAII device. Please
read "eSATAII Interface Introduction" on page 33 for details about
eSATAII and eSATAII installation procedures.
2 6 2 6 2 6
2 6 2 6
ASRock 4Core1600P35-WiFi+ / 4Core1600P35-WiFi Motherboard
80-conductor ATA 66/100/133 cable
These six Serial ATAII (SATAII)
connectors support SATA data
cables for internal storage
SATAII_1 (Port0)
devices. The current SATAII
interface allows up to 3.0 Gb/s
SATAII_2 (Port1)
data transfer rate.
SATAII_3 (Port2)
SATAII_4 (Port3)
the red-striped side to
Pin1
connect the black end
to the IDE devices
for the details.