Onboard Headers And Connectors - ASROCK 4CORE1600TWINS-P35 - V1.0 User Manual

Table of Contents

Advertisement

2.10 Onboard Headers and Connectors

2.10 Onboard Headers and Connectors
2.10 Onboard Headers and Connectors
2.10 Onboard Headers and Connectors
2.10 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.11 No. 25)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.11 No. 9)
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_1 (Port0):
see p.11, No. 12)
SATAII_5 (Port4)
(SATAII_2 (Port1):
see p.11, No. 16)
SATAII_6 (Port5) SATAII_2 (Port1)
(SATAII_5 (Port4):
see p.11, No. 11)
(SATAII_6 (Port5):
see p.11, No. 17)
SATAII_6 (Port5) connector can be used for internal storage device or
be connected to eSATAII connector to support eSATAII device. Please
read "eSATAII Interface Introduction" on page 33 for details about
eSATAII and eSATAII installation procedures.
FLOPPY1
Pin1
IDE1
PIN1
These four Serial ATAII (SATAII)
connectors support SATA data
cables for internal storage
SATAII_1 (Port0)
devices. The current SATAII
interface allows up to 3.0 Gb/s
data transfer rate.
2 7
2 7
2 7
2 7
2 7
the red-striped side to Pin1
connect the black end
to the IDE devices

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

4core1600twins-p35

Table of Contents