Input/Output Mode Settings - Omron H7CX-N Datasheet

H7CX-A@-N
Counter

Input/Output Mode Settings

I/O Functions for Counter Operation
If a 1-stage model or 2-stage model is incorrectly used as twin counter, the operation for
output 2 will be performed. When using a 2-stage model as a 1-stage preset counter,
total and preset counter, or dual counter, OUT1 and OUT2 turn ON and OFF
simultaneously.
Reset/
reset 1
999999
Set value 2
Set value 1
N
0
OUT1
OUT2
Reset/
reset 1
999999
Set value 2
Set value 1
F
0
OUT1
OUT2
Reset/
reset 1
999999
Set value 2
Output
Set value 1
mode
C
0
setting
OUT1
OUT2
Reset/
reset 1
999999
Set value 2
Set value 1
R
0
OUT1
OUT2
Reset/
reset 1
999999
Set value 2
Set value 1
K-1
0
OUT1
OUT2
22
Input mode
UP
Self-holding
output
DOWN UP/DOWN A, B, C
One-shot output from OUT1
(The one-shot output time can be
set in the range 0.01 to 99.99s.)
Self-holding One-shot
output output from OUT2
Operation after count
completion
The outputs and present
value display are held
until reset/reset 1 is
input.
The present value
display continues to
increase/decrease.
The outputs are held until
reset/reset 1 is input.
As soon as the count
reaches SV, the present
value display returns to
the reset start status.
The present value display
does not show the
present value upon count-
up.
The outputs repeat one-
shot operation.
OUT1 self-holding output
turns OFF after the OUT2
one-shot output time.
The OUT1 one-shot
output time is
independent of OUT2.
The present value
display returns to the
reset start status after
the one-shot output time.
The outputs repeat one-
shot operation.
OUT1 self-holding output
turns OFF after the
OUT2 one-shot output
time.
The OUT1 one-shot
output time is
independent of OUT2.
The present value
display continues to
increase/decrease.
OUT1 self-holding output
turns OFF after the
OUT2 one-shot output
time.
The OUT1 one-shot
output time is
independent of OUT2.