Cx-One Maintenance - Omron CX-ONE - SETUP 02-2009 Setup Manual

CX-One Maintenance

Note
2-2 CX-One Maintenance
1,2,3...
2-2-1 Modifying the Installed Support Software in the CX-One
Note
18. The Online Registration Dialog Box will be displayed when the Readme file
is closed.
A wizard will be started and will connect to the OMRON CX-One website
if the Register Button is clicked. (See notes a and b.)
Note (a) If the Exit Button is clicked to cancel registration, the Online Reg-
istration Dialog Box will be displayed every time CX-One Support
Software is started.
(b) Online installation will not be possible if the computer is not con-
nected to the Internet. Enter the required information on the reg-
istration card and mail it in.
This completes installation of the CX-One.
(1) Even if the previous versions for Support Software in the CX-One are un-
installed, the folders for the previous versions will remain in C:\Program
Files\OMRON. By default, the project files and other files that were creat-
ed by the Support Software (e.g., .cxp project files for CX-Programmer)
will be in this directory. If this data is to be used by the CX-One, we rec-
ommended moving the files to suitable folders after installing CX-One.
(2) Any OMRON Support Software or Communications Middleware that is
not included in CX-One will remain installed on the hard disk even after
the CX-One is installed. This will not create any particular problems.
Examples:
• DeviceNet Configurator (Support Software)
• FinsGateway (Communications Middleware)
The following maintenance can be performed once the CX-One has been
installed.
1. Modifying the installed Support Software in the CX-One
2. Re-installing the Support Software in the CX-One that was previously in-
stalled
3. Removing all the Support Software in the CX-One
The CX-One Support Software that is installed can be modified using the fol-
lowing procedure.
Whenever installing from an individual Support Software CD-ROM any Sup-
port Software that has previously been installed from the CX-One Package,
always uninstall the previous Support Software first. Use the following proce-
dure and clear the selection for only the individual Support Software to be
reinstalled. When the installation procedure has been completed, then install
the Support Software from the individual Support Software CD-ROM. The
Section 2-2
25