Switching The Headphones On And Off - Sennheiser RS 180 - 08-09 Instruction Manual

Switching the headphones on and off

WARNING Danger due to high volumes!
Listening at high volume levels for long periods can lead to
permanent hearing defects.
Switching the headphones on
Press the multi-function button
The headphones switch on. The multi-function LED
1s
indicating that the headphones are in enrollment mode.
Once the headphones have found a suitable transmitter, the
transmitter pairs with the headphones and transmits an audio signal.
5s
The multi-function LED
button
Switching the headphones off
Press the multi-function button
The multi-function LED
mode.
If there is no signal from the transmitter for more than 5 minutes,
the headphones automatically switch to standby mode.
Before putting the headphones on, set the volume to a low
level.
Do not continuously expose yourself to high volumes.
²
for approx. 1 second.
µ
of the headphones and the multi-function
of the transmitter flash slowly.
3
²
for approx. 1 second.
µ
goes off. The headphones are in standby
Using the RS 180
µ
flashes green,
µ
21