Table of Contents
Advertisement
Available languages
Available languages
48
Using the appliance
DELAY START (STARTUITSTEL)
Allows to delay the start of a drying programme from minimum of 30 min. to maximum of
20 hours.
1. Select the drying programme and additional options.
2. Push the DELAY START (STARTUITSTEL) button again and again until the necessary delay
start is shown in the display, e.g.
3. To activate the delay timer, push the START PAUSE (START PAUZE) button. Time to start
elapses in the displayed.
Setting child lock
The child lock can be set to prevent a programme being accidentally started or a pro-
gramme in operation being accidentally changed. The child lock function locks all buttons
and the programme dial. The child lock can be activated or deactivated by holding down
the LONG ANTI-CREASE (ANTIKREUK LANG) and BUZZER (ZOEMER) buttons at the same
time for 5 seconds.
– Before programme is started: Appliance cannot be used
– After programme is started: Programme in operation cannot be changed
The padlock symbol
vated.
The child safety device is not deactivated once the programme comes to an end.
If you want to set a new programme, you must first deactivate the child safety device.
Starting the programme
Push the START PAUSE (START PAUZE) button (6). The programme is started.
The programme progress is shown in LCD by appropriate set of icons. From left to the right,
from iron dry
cupboard dry programme the following status icons are visible:
cycle progress is marked by flashing dash under status icon. When appropriate part of dry-
ing cycle is accomplished dash becomes steady and appears flashing under next status icon.
Changing programme
To change a programme which has been selected by mistake once the programme has star-
ted, first turn the programme selector to OFF and then reset the programme.
The programme cannot longer be changed directly once the programme has started. If nev-
ertheless there is an attempt to change the programme on the programme dial, the pro-
gramme progress display and the maintenance indicators flash. If an option (excluding the
buzzer ) is set, Err appears in the multidisplay. The drying programme is not however affec-
ted by this (laundry protection).
Programme complete / Laundry unloading
Once the drying cycle is complete, display shows a blinking
appears dash. If the buzzer option has been set, an acoustic signal sounds intermittently for
about one minute.
appears in the display to indicate that the child safety device is acti-
to anti-crease
icon depends on the drying cycle chosen. E. g. in case of
if the programme has to start after 12 hours.
, under anti-crease
. Current
icon
Advertisement
Chapters
Table of Contents
