Parts & Features - LG LTEL7337D.BBDLLGA Owner's Manual

Problem
Food does not broil Aluminum foil used on the broiling pan and grid has not been fitted properly and slit as
properly recommended.
• See the "Oven" section in the Operation chapter.
In some areas the power voltage may be low.
• Preheat the broil element for 5-7 minutes. See the Broiling Guide.
Oven temperature Oven sensor needs to be adjusted.
too hot or too cold
• See the "Calibrating the Oven Temperature" section in the Operation chapter.
Excessive smoking Excessive soil.
during a Self Clean
• Turn off the Self Clean function. Open the windows to rid the room of smoke. Wait until the
cycle (On some
models)
Burning or oily odor This is normal in a new oven.
emitting from the
• This will disappear in time. To speed the process, set a Self Clean cycle for a minimum of 3
vent
Moisture collects on This happens when cooking foods high in moisture.
oven window or
• This is normal.
steam comes from
oven vent
Excessive moisture was used when cleaning the window.
• Do not use excessive moisture when cleaning the window.
Parts & Features
Problem
Range is not level. Poor installation.
• Place oven rack in center of oven. Place a level on the oven rack. Adjust leveling legs at
• Be sure floor is level and strong and stable enough to adequately support range.
• If floor is sagging or sloping, contact a carpenter to correct the situation.
Kitchen cabinet alignment may make range appear unlevel.
• Be sure cabinets are square and have sufficient room for range clearance.
Cannot move Cabinets not square or are built in too tightly.
appliance easily.
• Contact builder or installer to make appliance accessible.
Appliance must be
accessible for
Carpet interferes with range.
service.
• Provide sufficient space so range can be lifted over carpet.
Anti-tip device engaged.
• Uninstall the anti-tip device to move the range. Reengage the anti-tip device after pulling
Surface units will not Improper cookware being used.
maintain a rolling
• Use pans which are flat and match the diameter of the surface unit selected.
boil or cooking is not
fast enough. In some areas, the power(voltage) may be low.
• Cover pan with a lid until desired heat is obtained.
Surface units do not A fuse in your home may be blown or the circuit breaker tripped.
work properly.
• Replace the fuse or reset the circuit breaker.
Self Clean mode is cancelled. Wipe up the excess soil and reset the clean.
hours. See the Self Clean section. (On some models)
base of range until the oven rack is level.
the range out for cleaning, service, or any other reason.
Possible Cause & Solution
Possible Cause & Solution
TROUBLESHOOTING 73