Cleaning And Maintenance - Whirlpool OMSK58CU1B Quick Manual

CLEANING AND MAINTENANCE

Make sure that the oven has
cooled down before carrying out
any maintenance or cleaning.
Do not use steam cleaners.
EXTERIOR SURFACES
Clean the surfaces with a damp microfibre cloth. If
they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
Do not use corrosive or abrasive detergents. If any of
these products inadvertently comes into contact with
the surfaces of the appliance, clean immediately with
a damp microfibre cloth.
INTERIOR SURFACES
• After every use, leave the oven to cool and
then clean it, preferably while it is still warm,
to remove any deposits or stains caused by
food residues. To dry any condensation that
has formed as a result of cooking foods with
a high water content, leave the oven to cool
completely and then wipe it with a cloth or sponge.
CLEANING THE CATALYTIC PANELS (ONLY IN SOME MODELS)
This oven could be equipped with special catalytic liners
that facilitate cleaning of the cooking compartment
thanks to their special self-cleaning coating, which is
highly porous and able to absorb grease and grime.
These panels are fitted to the shelf guides: When
repositioning and then refitting the shelf guides, make
sure that the hooks at the top are slotted into the
appropriate holes in the panels.
REMOVING AND REFITTING THE DOOR
1. To remove the door, open it fully and lower the
catches until they are in the unlock position.
2. Close the door as much as you can.
Take a firm hold of the door with both hands – do not
hold it by the handle.
Simply remove the door by continuing to close it
while pulling it upwards (a) at the same time until it is
released from its seating (b).
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
• To remove the remaining limescale from the bottom
of the cavity after
to clean the cavity with the products provided
by After Sales Service (please follow instructions
attached to the product).
Cleaning is recommended at least every 5 to 10
• The door can be easily removed and refitted to
facilitate cleaning of the glass
• Clean the glass in the door with a suitable liquid
detergent.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
To make best use of the catalytic panels' self-cleaning
properties, we recommend heating the oven to 200 °C
for around one hour using the "Convection Bake"
function. The oven must be empty during this time.
Then leave the oven to cool down before removing any
remaining food residues using a non-abrasive sponge.
Please note: Using corrosive or abrasive cleaning agents, stiff
brushes, pan scourers or oven sprays could damage the
catalytic surface and compromise its self-cleaning properties.
Please contact our After-sales Service if you require
replacement panels.
Put the door to one side, resting it on a soft surface.
3. Refit the door by moving it towards the oven,
aligning the hooks of the hinges with their seating
and securing the upper part onto its seating.
4. Lower the door and then open it fully.
Lower the catches into their original position: make
sure that you lower them down completely.
5. Try closing the door and check to make sure that
it lines up with the control panel. If it does not, repeat
the steps above.
Wear protective gloves.
The oven must be disconnected
from the mains before carrying
out any kind of maintenance
work.
cooking, we recommend
cooking cycles.
~60°
~15°
b
a
7