Table of Contents
Advertisement
11.
SECURE WORK.
Use
clamps or a vise to hold work. It's safer
than using your hand and it frees both hands to operate tool.
12.
DON'T OVERREACH. Keep proper footing and balance at all
times.
13.
MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean
for better and safer performance. Follow instructions for lubricating
and changing accessories. Inspect tool cords periodically and if
damaged, have repaired by authorized service facility. Inspect
extension cords periodically and replace if damaged. Have all worn,
broken or lost parts replaced immediately. Keep handles dry, clean
and free from oil and grease.
14.
DISCONNECT TOOLS. When not in use, before servicing,
and when changing accessories such as blades, bits, cutters, etc.
15.
REMOVE ADJUSTING KEYS AND WRENCHES. Form habit
of checking to see that keys and adjusting wrenches are removed
from the tool before turning it on.
16.
AVOID UNINTENTIONAL STARTING. Don't carry plugged-
in tool with finger on switch. Be sure switch is off when plugging in.
17.
OUTDOOR USE EXTENSION CORDS. When tool is used
outdoors, use only extension cords marked "Suitable for use with
outdoor appliances - store indoors when not in use."
18.
STAY ALERT. Watch what you are doing. Use common sense.
Do not operate tool when you are tired or while under the influence of
medication, alcohol or drugs.
19.
CHECK DAMAGED PARTS. Before further use of the tool, a
guard or other part that is damaged should be carefully checked to
determine that it will operate properly and perform its intended
function. Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other conditions that
may affect its operation. A guard or other part that is damaged should
be properly repaired or replaced by an authorized service center
unless otherwise indicated elsewhere in this instruction manual.
Have defective switches replaced by authorized service center. Do
not use tool if switch does not turn it on and off.
SAVE THESE INSTRUCTIONS
REPLACEMENT PARTS
When servicing use only identical replacement parts.
ADDITIONAL SAFETY RULES FOR PORTABLE DRILLS
1.
ALWAYS hold drill by the handle ONLY to prevent accidental
electrical shock resulting from cutting a live wire when drilling into a
wall or other blind areas.
2
.
DO NOT use bits larger than those recommended. Large bits
may overload the drill and damage the motor and gears.
3
.
USE ONLY the proper chuck key to tighten or loosen the chuck.
Do not use chuck if jaws or other parts are cracked or worn.
3
Advertisement
Table of Contents
