Operation For Transmission And Reception Of Video And Audio Signals - Sharp AQUOS LC-15L1U Operation Manual

OPERATION FOR TRANSMISSION AND RECEPTION OF VIDEO AND AUDIO SIGNALS
Preparation
To confirm the TV main unit correctly receives the video and audio signal output by the Wireless Center, first put
these devices closely together.
Page
1. Connecting an antenna to the Wireless Center 12
2. Connecting an external equipment to the Wireless Center 55
3. Switching on the power of the Wireless Center
22
4. Switching on the power of the TV main unit and the external equipment 22
( 5. Performing
uCH-SETTING"
43 )
6. Select a TV channel using the remote control and
confirm broadcast programs are received correctly 34
7. Switching between TVNIDEO using the remote control 32
8. Perform playback operations, etc. of the external equipment using the remote control to check
correct reception
(In case reception does not take place correctly, reconfirm the connections)
Check the video controller correctly points to the infrared receiver
of the remote control for the external equipment 57
9~ Move the TV main unit to the desired location and check for correct reception
• Correct reception may not be possible in locations where radio waves cannot reach or when other
conditions exist that obstruct the radio waves.
In this case, change the location of the receiver to a place where it receives signals correctly.
• Since the "CHANNEL" of the "TRANSMISSION SETTING" is set to "AUTO", the viewing conditions may
improve when the setting is reset.