Intended Use - Dometic CFX2 Series Short Operating Manual

• If the device is le empty for long periods:
Switch off the device.
Defrost the device.
Clean and dry the device.
Leave the lid open to prevent mould developing within the device.
NOTICE! Damage hazard
• Check that the voltage specification on the type plate corresponds to that of the energy supply.
• Only connect the cooling device as follows:
With the DC connection cable to a DC power supply in the vehicle
Or with the AC connection cable to an AC power supply
• Never pull the plug out of the socket by the cable.
• If the cooling device is connected to a DC outlet: Disconnect the cooling device and other power
consuming devices from the battery before connecting a quick charging device.
• If the cooling device is connected to a DC outlet: Disconnect the cooling device or switch it off
when you turn off the engine. Otherwise you may discharge the battery.
• The cooling device is not suitable for transporting caustic materials or materials containing solvents.
• The insulation of the cooling device contains flammable cyclopentane and requires special disposal
procedures. Deliver the cooling device at the end of its life-cycle to an appropriate recycling center.
• Do not place the cooling device near naked flames or other heat sources (campfires, heaters, direct
sunlight, gas ovens etc.).
• Do not fill the inner container with ice or fluids.
• Never immerse the cooling device in water.
• Protect the cooling device and cables against heat and moisture.
• The cooling device shall not be exposed to rain.
• To enable the refrigerant to circulate properly, the cooling device may not tilted by more than 30 °.
Use a spirit level to ensure the cooling device is level.
• Risk of overheating! Ensure at all times that there is sufficient ventilation on all four sides of the
cooling device. Keep the ventilation area free of any objects that could restrict the air flow to the
cooling components. Do not place the cooling device in closed compartments or areas with none
or minimal air flow.

5 Intended use

The portable fridge is suitable for cooling and freezing food. The portable fridge is also suitable for use in vehicles.
The portable fridge is designed to be operated from a DC power supply socket of a vehicle or from an AC power
supply.
The portable fridge is also suitable for camping use.
The portable fridge is not suitable for:
• Quick freezing food
• Storage of corrosive, caustic, or solvent-containing substances
• Use as a built-in appliance
This portable fridge is only suitable for the intended purpose and application in accordance with these instructions.
CFX2 28, CFX2 37, CFX2 45, CFX2 57 EN
5