Installing The Idsdm Module - Dell CGJH2 Installation And Service Manual

Figure 71. Removing the IDSDM module
Next steps
Replace the IDSDM module.

Installing the IDSDM module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the air shroud.
Steps
1. Locate the IDSDM connector on the system board.
To locate IDSDM, see the
2. Align IDSDM module with the connector on the system board.
3. Push IDSDM module until it is firmly seated in the connector on the system board.
82 Installing and removing system components
Safety instructions.
Before working inside your
System board jumpers and connectors
system.
section.