Nationwide Industries CornerStone 2 Manual

PATENTED
SELF-CLOSING ORNAMENTAL HINGE
HINGE MOUNTING:
1. First, choose the desired direction of mounting.
Applications using larger post and gate frames should
mount the hinge so that the vertical adjustment is on
the fence post and the horizontal adjustment is on the
gate frame (Fig. 1). Applications with smaller gate
frames (1.5" - 2") should mount the hinge so that the
vertical adjustment is on the gate frame and the
horizontal adjustment is on the post (Fig. 2).
2. The brackets should be positioned on the outside
surfaces of the posts with the gate in the closed
position (Fig. 3). The top edge of the upper hinge
should be mounted within 6" of the top surface of the
top rail, and the bottom edge of the lower hinge
should be mounted within 6" of the lower surface of
the lower rail (Fig. 4). In applications where additional
hinges are used, they should be evenly spaced
between the upper and lower hinges. The mounting
brackets with horizontal locking grooves are for the
vertically adjustable side of the hinge, while the
brackets with the vertical locking grooves are for the
horizontally adjustable side of the hinge.
3. Install self-closing hinge assembly to mounting brackets
(installed in step 2) and secure with washers and acorn
nuts (use hand tools only). Hinge should be positioned
as shown so that the locking grooves on the mounting
brackets will align with grooves on the back side of the
hinge assembly (Fig. 5).
Post
nationwideindustries.com | Info@nationwideindustries.com | 813-988-2628
C2H200F & C2H300F
Gate
Acorn Nut
(USE HAND TOOLS ONLY)
Fig. 1
Fig. 2
Fence Post
Smaller Bracket
(Vertical adj.)
C L
FENCE PRO'S
#1 CHOICE
C2H200F C2H300F
SCAN FOR MORE
INFORMATION
Gate gap must be 0.4 to 1.3"
Gate Frame
Hinge
Mounting
Brackets
Fig. 3
6"
Larger bracket
(Horizontal adj.)
Fig. 4
C2H200F/C2H300F