Table of Contents
Advertisement
INSTALLATION
• The hood can be installed either directly on the bottom surface
of the wall units using snap-on side supports.
• Cut a fitted opening in the bottom surface of the wall unit, as
shown.
• Insert the hood until the side supports snap into place.
• Lock in position by tightening the screws Vf from underneath
the hood.
• The hood can be installed either directly on the bottom surface
of the wall units (min. 650 mm above the hob) using snap-on
side supports.
• Cut a fitted opening in the bottom surface of the wall unit, as
shown.
• Fix using the 8 screws 12a provided.
EN
SNAP-ON FITTING
SNAP-ON FITTING
1
12
2
Advertisement
Table of Contents
