Table of Contents
Advertisement
Setting
The amount of salt dispensed can be
set to 4 levels, depending on the
hardness of your water. 0, 1, 2 or 3
displays light up (see table) according
to your selection. Factory setting: 1.
1. Determine the hardness of your tap
water. Your water utility can help you
here.
2. The required setting can be found in
the following water hardness table.
3. Open the door.
4. Switch on ( ON/OFF switch.
Water hardness table
Water softening system/Special salt
5. Hold down P > button and press
h START button until the ` Dry
indicator and )* Salt refill indicator
flash.
6. Release the buttons.
The )* Salt refill indicator ` Dry
indicator flash.The # indicator
lights up (= level 1).
To change the setting:
1. Press H < button until the required
level has been selected.
2. Press h Start button.
The ` and )* indicators go
out.The level selected is saved.
3. Close the door.
en
11
Advertisement
Table of Contents
