●
BID Engage calibration is performed, via Main Menu > Ink and BID > BID > Full BID Engage.
NOTE:
The overlap prevention parameters will not be saved if a job is removed from the press, or the
press is shut down.
Enabling double-hit printing on press for HP Indigo ElectroInk
Silver
Follow these steps to enable double-hit printing for HP Indigo ElectroInk Silver.
For jobs that require higher opacities of HP Indigo ElectroInk Silver, you can increase the number of
Silver separations.
NOTE:
It is recommended to use HP Indigo ElectroInk Silver with 2 hits in order to reach the OD
(optical density) targets. This can be done from the pre-press (DFE).
1.
Open the
2.
Open the Ink Order tab.
3.
Select Silver in the
4.
Enter 2 in the correspondent text box.
5.
Touch Apply and OK.
Recommended maintenance
Following are the maintenance recommendations.
Start of day maintenance
●
Clean the BID:
–
Gap between electrodes (after developer roller removal).
Use the dedicated BID Cleaning Jig (P/N CA497-03570).
20
Chapter 4 Working with HP Indigo ElectroInk Silver
Job Properties screen, Separations tab.
Separation column.