Smeg DWD1SSE-1 Instruction Manual page 9

POWER SWITCH-ON
In order to switch on the appliance just turn the ON/OFF selector (2) till it corresponds with the
letter I.
TABLE FOR CERTIFICATION BODIES
Reference standard
Reference program
Load
Type of detergent
Amount of detergent
Rinse aid setting
DISABLING THE END OF CYCLE ACOUSTIC DEVICE
It is possible to disable the sounding of the start/end of cycle acoustic device.
Proceed as follows:
•
•
•
To re-enable the acoustic device repeat the following procedure:
•
•
•
34
User instructions
press down the HALF LOAD (4) button for a few seconds until the symbol bS appears on the
INFORMATION DISPLAY (6);
press the HALF LOAD (4) button again to disable the acoustic device (the symbol bN appears
on the display);
press the START/STOP (3) button twice to exit the set-up mode.
press down the HALF LOAD (4) button for a few seconds until the bN symbol appears on the
INFORMATION DISPLAY (6);
press the HALF LOAD (4) button again to enable to acoustic device (the symbol bS appears);
press the START/STOP (3) button twice to exit the set-up mode.
(*) Selector on P6 + ECO DRYING
14 place-settings
Depending on the model 3/4 or 4/6
EN 50242
EN 50242
B
35 g