Table of Contents
Advertisement
CONNECTIONS FOR EACH COMPONENT
e Remember to turn off the power to all of the units before making any
connections.
|
e When making the connections, keep all cables well away from sources
of hum, such as power cords or the power transformers in other
components.
Notes on REMOTE CONTROL terminals
The REMOTE CONTROL terminals are used when you have YAMAHA .
compatible components bearing the 226 mark. These terminals allow
you to control the connected components with the supplied remote
control transmitter.
Connect the remote control cables from the components to the correct
terminals on your amplifier (і.е. PHONO, TUNER, ТАРЕ).
Note that no cable is necessary for a CD or CDV player as the remote
control transmitter operates the player directly.
Remote cable with mini-plug connectors,
|
specially for use with a turntable with
|
bearing the == mark.
AUDIO COMPONENTS
Ш TURNTABLE
Connect the output cables of the turntable to the PHONO jacks, and
connect the ground wire to the GND terminal on the rear panel of this
unit. This should produce minimum hum, but in some cases better results
are obtained with this wire disconnected. When a turntable bearing the
=== mark is used, connect the remote control terminal on the turntable
to the REMOTE CONTROL PHONO terminal on the rear panel of this
unit, using the supplied remote cable with mini-plug connectors.
AVX-100U
Turntable
Advertisement
Table of Contents
