Shifting - Yamaha FZ6 2006 Owner's Manual

OPERATION AND IMPORTANT RIDING POINTS
serve the battery. Do not crank the en-
gine more than 10 seconds on any one
attempt.
CAUTION:
G If the oil level warning light flick-
ers or remains on after starting,
immediately stop the engine,
and then check the engine oil
level and the vehicle for oil leak-
age. If necessary, add engine
oil, and then check the warning
5
light again.
G If the coolant temperature warn-
ing light flickers or remains on
after starting, immediately stop
the engine, and then check the
coolant level and the vehicle for
coolant leakage. If necessary,
add coolant, and then check the
warning light again.
G
If the engine trouble warning
light flashes or remains on after
starting, immediately stop the
engine, and have a Yamaha
dealer check the cause.
G
The immobilizer system indica-
tor light should come on when
the key is turned to "ON", and
then go off after a few seconds.
ECA15395
If the indicator light does not
come on, or does not go off, or
if it flashes and the display indi-
cates a two-digit error code,
have a Yamaha dealer check the
electrical circuit.
CAUTION:
For maximum engine life, always
warm the engine up before starting
off. Never accelerate hard when the
engine is cold!
NOTE:
The engine is warm when it quickly re-
sponds to the throttle.

Shifting

ECA11130
1. Shift pedal
2. Neutral position
Shifting gears lets you control the
amount of engine power available for
starting off, accelerating, climbing hills,
etc.
The gear positions are shown in the il-
lustration.
NOTE:
To shift the transmission into the neu-
tral position, press the shift pedal down
repeatedly until it reaches the end of its
travel, and then slightly raise it.
5-2
EAU16671