Input; Ac Inrush Current; Line Dropout; Output - HP Vectra Reference Manual

Hide thumbs Also See for Vectra:
Table of Contents

Advertisement

Input
The two line voltage levels are user-selectable by a switch and
protected by an accessible five amp fuse. This fuse is shown in
figure 16 and is easily accessible from the back panel of the unit.
Should the fuse need to be replaced, use a fuse of the same type
and rating, HP product number 2110-0729. The following chart
defines the voltage input range.
Input Voltage
110V (
+
10 % - 25%)
@
50/60 Hz (
+ / -
5%)
230V (
+
10 % - 25%)
@
50/60 Hz (
+ / -
5%)
AC Inrush Current
AC inrush current is limited to 40 amps under any condition.
Inrush current shall not open the line fuse under any condition.
Line Dropout
The power supply will continue regulated operation when a 20ms
dropout occurs at the input under any condition, including low
line at rated load.
Output
The HP Vectra PC establishes a five output power supply as
defined in the following table.
Power Supply
75

Advertisement

Table of Contents
loading

Table of Contents