Table of Contents
Advertisement
3.2
Connecting to PC/Force Recovery Mode
Step 1:
On the Host computer, open the Linux terminal and enter the following command to
extract the compressed BSP image files (BSP file name may vary):
$ sudo tar -zxvf BOXER-8623AI_J5.1.1_A00_1.0.0_20230908.tar.gz
Note: Do not decompress the file (Internal.tar.gz) using a Windows OS, BSP should only
be decompressed in a Linux EXT3/4 file system.
Step 2:
Perform the following actions to force the system to start in USB Recovery Mode:
1.
Connect the Micro-USB plug on the USB cable to the Recovery Port on the
BOXER-8623AI, and the other end to an available USB port on the Host PC.
2.
Connect the BOXER-8623AI to a power supply.
3.
Press and hold the recovery key button. While holding the recovery key button,
power on the system, and continue to hold the recovery key button for two seconds,
then release. The BOXER-8623AI should then enter recovery mode.
4.
To check if device is in recovery mode, enter the command
Host.
$ lsusb | grep "0955:7623"
If successful, the command will return
Chapter 3 – BSP Flash Guide
"0955:7623 NVidia
Corp"
lsusb
in terminal on
29
Advertisement
Table of Contents
