Related Manuals for Sana 878
Summary of Contents for Sana 878
- Page 1 Sana 878 vertical juicer Instruction Manual [ Home use only / Warranty card included separately ]...
-
Page 2: Table Of Contents
TABLE OF CONTENTS heavy object on top of the product or wedge it into a narrow space. 1. Safety precautions P.02 • Do not modify, disassemble, or attempt to repair the product. P.03 2. Precautions during use • Do not insert any foreign objects such as a finger P.04 3. -
Page 3: Precautions During Use
• If the device produces any unusual sounds, • Do not operate it for more than 30 minutes smells, excessive heat, or smoke, stop using it continuously. Allow the motor to cool at least 5 immediately and contact an authorized service minutes if run for 30 minutes. -
Page 4: Power Dial
4. Precautions Before Juicing 3. Power Dial Make sure the dial is set to the off (o) Please be aware of any food allergies of anyone position before plugging in the power cord. who will consume the juice or nut milk. Cut produce into pieces which will fit into the hopper. -
Page 5: Ingredient Preparation
It can also be used to make smoothies by mixing juicing produce with softer ingredients like bananas, berries, or mangos. The sorbet screen turns the Sana 878 into a frozen dessert Sorbet machine. By using slightly thawed frozen fruit, a wide variety... -
Page 6: Assembly
6. Assembly ④ ④ ④+⑤ ④+⑤ ⑦ ⑦ ⑤ ⑤ ① ② ② ② ⑦ ⑦ ⑦ ⑦ ⑧ ⑧ Note: See section 10 “Sorbet screen” if using the sorbet screen. Insert fine or coarse screen (4) all the way in the rotating brush (5). 01 01 Insert the screen and brush assembly into the juicing chamber (7) by aligning the large and small 02 02... -
Page 7: Silicone Parts
7. Silicone parts Silicone parts keep the juicer from leaking, and can Hopper gasket be removed for deep cleaning. Pulp outlet gasket Pull from one side outward, then down to remove. Pulp outlet seal gasket To install, stretch it into it the groove on the hopper. Juice cap gasket Remove the pulp outlet gasket by pulling up on the flap. -
Page 8: How To Use
8. How to use... -
Page 9: If The Juicer Jams
9. If the juicer jams 1. Open the hopper lid by pressing the release tab firmly. 2. Add ingredients into the hopper below the fill line. If using a mix of ingredients, put softer ingredients like greens and berries in the bottom and harder ingredients like carrots and beets at the top. -
Page 10: Sorbet Screen
10. Sorbet screen Product Specifications TIPS: • Do not fill the hopper with frozen fruit. Only Size Ø147 mm x 94 mm feed pieces individually and slowly through the hole in the hopper lid. 160 g Weight • Allow frozen fruit to slightly thaw, especially dense fruit like strawberries. -
Page 11: Disassembly And Cleaning
11. Disassembly and cleaning After turning of the power dial to the OFF position, wait 3 seconds for the motor to come to a complete stop and unplug the power cord before removing the juicing assembly. 1. Lift the juicing chamber from the motor base, and remove the hopper by turning it to the unlock position. -
Page 12: 12. Troubleshooting
12. Troubleshooting Before contacting your retailer for repair, please check the following points: This is normal, and is simply the sound of the motor engaging with the juicing 01. A „click“ sound is heard when turning on the juicer. chamber. 02. -
Page 13: Parts List
13. Parts list ① ② ②-1 ①-1 ②-2 ①-2 ①-3 ②-5 ②-3 ②-4 ⑤ ⑥ ⑥-1 ④ ③ ③-1 ④-1 ⑦ ⑦-1 (Closed) (Open) ⑦-2 -2 ⑦-4 ⑦-3 ⑦-7 ⑦-5 ⑦-6 ⑦-8 ⑦-10 ⑦-9 1. Hopper cover 7-2 Chamber locking mark ⑧... -
Page 14: Specifications
14. Specifications Product Specifications Juicer Power Cord Product 1.4 m and over Length Model Motor Single-Phase Induction 220 - 240 V Rated Voltage Fuse 250 V 8 A 50 / 60 Hz Rated Frequency 6.2 kg Weight 200 W ( Higher watt W 243mm / L 251mm / H 477 Rated Power...