Control 4 CORE 1 Installation Manual

CORE 1 Rack-Mount Kit
Installation Guide
Box contents
• C4-CORE1-RMK Control4 CORE 1 Rack-Mount Kit
Description
The CORE 1 Rack-Mount Kit makes it easy to install the Control4 CORE 1 Hub and Controller in an equipment rack. A removable face plate means
this shelf can hold one or two controllers with a clean, finished look. A retention bar secures the controller(s) in place, and the rear of the shelf
includes metal loops for convenient cable management.
Install the Controller(s) in the Rack Shelf
1. Loosen (but do not remove) the lock screw, until you
can lift the retention bar up as far as it can go.
2. Lift the retention bar and slide the CORE 1 into
position. Ensure the front of the CORE 1 fits flush with
the face of the shelf.
Install a Second Controller (optional)
3. Remove the lock nut and washer that secures the
faceplate. Remove the faceplate.
4. Slide the second CORE 1 into position (just as
you did in step 2). Ensure the front of the second
controller is also flush with the face of the shelf.
Secure the Controller(s)
5. Lower the retention bar so it sits in the grooves
on the CORE 1 Controller(s). Tighten the lock screw.
Check that the controller(s) cannot move.
Install the Shelf into the Rack
Make all necessary connections for the CORE 1
controller(s), then insert the rack shelf and secure with
rack screws (not included).
1 1