Advertisement
5. OPERATION
5.1.
Prior to use of the required
attachment, disassemble and
grease as shown in fig.1.
Reassemble the attachment.
5.2.
Screw the attachment into the
shaft, as shown in fig.2. Tighten
the attachment using a wrench.
NOTE: DO NOT over tighten.
5.3.
Ensure the attachment jaws
are completely closed and insert
the attachment into the inner
diameter of the bearing, fig.3.
5.4
Turn the handle clockwise to
open the attachment jaws to
grip the bearing. See fig.4.
5.5.
Hold the bearing puller as shown
in fig.5, slide the hammer to the
bearing end of the shaft and
then forcefully pull the hammer
to the other end of the shaft.
5.6.
Ensure the bearing is being
pulled out evenly, if not, remove
the puller attachment and, using
a soft faced mallet, tap the
bearing until it is seated evenly.
5.7.
Repeat paragraphs 5.5 and 5.6
until the bearing has been
removed.
5.8.
Turn the handle anticlockwise to
close the jaws in order to
release the bearing from the
attachment head. See fig.5.
6. MAINTENANCE
6.1.
After use, account for all components, clean with a lightly oiled cloth and return them to the carry case.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice. Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call
our technical team on technical@sealey.co.uk or 01284 757505.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
Grease
Fig.1
Attachment Head
Tighten
Fig.2
Bearing
Attachment Head
Fig.3
Attachment Head
Fig.4
Hammer
Attachment Head
Fig.5
Hammer
Loosen
Open jaws
Close Jaws
www.sealey.co.uk
AK714.V4
Issue 1
08/07/20
Advertisement
