Sealey AK714.V4 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
WARNING! Ensure that Health and Safety, local authority and general workshop practice regulations are adhered to when using this
‰
product.
DO NOT use this product if damaged.
8
Maintain product in good and clean condition for best and safest performance.
9
If the vehicle to be worked on is raised, ensure that it is adequately supported with axle stands or ramps and chocks.
9
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey dealer.
9
Wear suitable clothing to avoid snagging. DO NOT wear loose jewellery and tie back long hair.
9
Account for all tools and parts being used.
9
If working off the vehicle, secure the work piece in a vice or clamp it to a work bench.
9
DO NOT operate puller if you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
IMPORTANT: Always refer to the vehicle manufacturer's service instructions, or a proprietary manual, to establish the current
procedure and data. These instructions are provided as a guide only.
2. INTRODUCTION
Fully chromed carbon steel medium stroke slide hammer. 370mm Overall length with 0.85kg hammer. Bearing extractor collets with
internal capacity from 11 to 32mm. Supplied in storage case.
3. SPECIFICATION
Model No.: ............................................................. AK714.V4
Collet Sizes Ø: ........................................11-16mm (3/8-1/2")
............................................................15-19mm(9/16-11/16")
................................................................... 18-25mm(5/8"-1")
................................................................. 26-32mm(1-1 1/4")
4. CONTENTS
11mm - 16mm Attachment (Part No: AK714.V4-01)
15mm - 19mm Attachment (Part No: AK714.V4-02)
18mm - 25mm Attachment (Part No: AK714.V4-03)
26mm - 32mm Attachment (Part No: AK714.V4-04)
Slide hammer
Blow Mould Case
© Jack Sealey Limited
5PC BLIND BEARING PULLER SET
MODEL NO:
Wear protective
Wear safety
gloves
footwear
(Part No: AK714.V4-05)
(Part No: AK714.V4-06)
Original Language Version
AK714.V4
Wear protective
clothing
AK714.V4 Issue 1 08/07/20