Installing The Refrigerator-Freezer; Cica Wace Ceuinio) Ac Satnnaemcnnerianeeseuaieasas Ia; Hog Acai S Hile Obuaicea Ernment Renasetctaceteuse Sles; Logale Pioderve Acstasdonvint Evn Thsetcecithee Eet - KitchenAid Superba Series Use And Care Manual

Installing the Refrigerator- Freezer
Clean It
Clean your refrigerator before using
it. See cleaning instructions on
page 14.
Remove the Consumer Buy Guide
label and any shipping tape before
using the refrigerator.
To remove any remaining glue:
1. Rub briskly with thumb to make a
ball, then remove.
OR
2. Soak area with liquid hand
dishwashing detergent before
removing glue as described in
Step |.
IMPORTANT: DO NOT USE
rubbing alcohol or flammable or
toxic solvents, such as acetone,
gasoline, carbon tetrachloride, etc.
These can damage the finish.
DO NOT REMOVE THE
INSTRUCTION LABEL FOR SETTING
THE CONTROLS INSIDE THE
REFRIGERATOR.
DO NOT REMOVE the Tech Sheet
fastened under the refrigerator,
behind the base grille.
Plug It In
3-prong grounding
type wall receptacle
3-prong
grounding plug
Recommended grounding method
£5
Refrigerator
power cord
A 115 Volt, 60 Hz., AC only, 15 or
20 Amp fused and properly
grounded electrical supply ts
required. It ts recommended that a
separate circuit serving only this
appliance be provided.
Do not use an extension cord.
Use a receptacle which cannot
be turned off with a switch or
pull chain. See Electrical
Requirements and Grounding
Instruction Sheet in your Literature
Package.
Locate Properly
1. Allow 172 inch (1.25 cm) on
each side of the refrigerator for
ease of installation.
2. If the refrigerator is to be against
a wall, you might want to leave
extra space on the hinge side so
the door can be opened wider.
3. The refrigerator back can be flush
against the wall.
Level Refrigerator-Freezer
Right to raise;
screw
Use screwdriver
to adjust
Lower
1. Remove base grille. (See page 10.)
2. To raise front, turn each screw to
the right.
3. To lower front, turn each screw to
the left.
4. Check with level.