Table of Contents
Advertisement
Installation
6" (15.2 cm)
CAUTION
• Ensure the exhaust outlet diameter and duct diameter match, and then connect
the duct to the wall outlet.
• If the duct and the wall outlet have different diameters, the suction performance
will decrease while significantly increasing noise.
The manufacturer is not responsible for any problems caused by this.
• Use the minimum possible length for the duct, and do not significantly alter the
cross-section.
• Minimize bending when connecting the duct (max bending angle: 90 degrees).
14 English
12. Fix the Flexible Duct (6" (15.2 cm)) to
the hood outlet and the vent on the
wall, respectively, with tape.
13. Fix the duct cover mounting bracket
to the ceiling or rear wall with the
30 mm screw anchors.
CAUTION
• Install the upper duct closely to the
ceiling and upper cabinets.
• Be careful not to let the upper duct
come into contact with the upper
cabinet door.
Electrical Connection
WARNING
Assembly and electrical connections must be carried out by qualified technician.
WARNING
Electrical Shock Hazard
Turn off power circuit at the service panel before wiring this unit.
120 VAC, 15 or 20 Amp circuit required.
Failure to do so can result in death or electrical shock.
Connect ground wire to Green/Yellow ground wire in terminal box.
To protect you against electric shock, The Green/Yellow Wire must
be connected to the grounding wire in home electrical system.
Failure to do so can result in death or electrical shock.
It must under no circumstances be cut or removed.
Terminal
box cover
Terminal
box
14-1.
Disconnect power circuit
breaker.
14-2.
Remove terminal box cover.
Advertisement
Table of Contents
