Table of Contents
Advertisement
en Time-setting options
8.8 Keeping warm over an extended period
You can use your appliance to keep meals warm for up
to 24 hours without changing the behaviour of the ap-
pliance. Use the time functions and change the basic
settings.
Note: If you open the appliance door during operation,
the appliance stops heating. When you close the appli-
ance door, the appliance continues to heat again. To
ensure that the behaviour of the appliance is not
changed during operation, only open the appliance
door once the set time has elapsed.
Change the basic settings.
1.
→ "Basic settings", Page 19
Change the "Lighting" basic setting to "Always
‒
off".
Change the "Standby screen" basic setting to
‒
"On".
Change the "Signal tone" basic setting to "Very
‒
short duration".
a This will ensure that the light in the cooking com-
partment is always off while the appliance is in oper-
ation and when you open the appliance door. The
clock display does not change. The duration of the
signal tone is reduced at the end of the operation.
Time-setting options
9 Time-setting options
For an operation, you can set the cooking time and the
time at which the operation should be finished. The
timer runs independently of the operation.
Time-setting
Use
option
Cooking time
If you set a cooking time, the appli-
ance stops heating automatically
once this time has elapsed.
End time
Along with the cooking time, you can
set the time at which you want the
operation to end. The appliance
starts up automatically so that the
operation finishes at the required
time.
Timer
You can set the timer to run inde-
pendently of the appliance during op-
eration. It does not affect the appli-
ance.
9.1 Setting the cooking time
You can set the cooking time for the operation up to
24 hours.
Requirement: An operating mode and temperature or
level have been set.
1.
Press
"Cooking time".
To set the cooking time, press the relevant time
2.
value, e.g. hour display "h" or minute display "m".
a The selected value is marked in blue.
Use the setting ring to set the cooking time.
3.
If required, use
to reset the setting value.
To confirm the set cooking time, press
4.
play.
14
Set the required operating mode.
2.
→ "Setting the operating mode", Page 13
→ "Setting the type of heating and the temperature",
Page 13
Set the required cooking time depending on the op-
3.
erating mode.
→ "Setting the cooking time", Page 14
→ "Time-setting options", Page 14
Use "End time" to set the time at which the opera-
4.
tion should end.
→ "Setting the end time", Page 14
→ "Time-setting options", Page 14
Place the food in the cooking compartment before
5.
the appliance starts to heat.
Press
6.
a The display shows the time remaining until the oper-
ation starts. The appliance is in standby mode.
a Once the start time has been reached, the appli-
ance starts heating and the cooking time starts
counting down.
7.
When the operation has ended, remove the food
from the cooking compartment. The appliance auto-
matically switches off completely after approximately
15 to 20 minutes.
Note: If required, change the different basic settings
again.
Press
5.
a The appliance starts to heat and the time counts
down.
a When the time has elapsed, a signal sounds. A
message appears on the display confirming that the
operation has finished.
Once the cooking time has elapsed:
6.
‒
‒
Changing the cooking time
You can change the cooking time at any time.
Press
1.
Press the cooking time
2.
Use the setting ring to change the cooking time.
3.
To confirm the change, press
4.
a The change is applied.
Cancelling the cooking time
You can cancel the cooking time at any time.
Press
1.
Press the cooking time
2.
Reset the cooking time using
3.
Note: For operating modes that always require a
cooking time, the appliance resets the cooking time
to the preset value.
To confirm the change, press
4.
a The change is applied.
9.2 Setting the end time
on the dis-
You can delay the time at which the cooking time for
the operation is due to end by up to 24 hours.
to start the operation.
to start the operation.
If required, you can select other settings and re-
start the operation.
When the food is ready, use
pliance off.
on the display.
.
on the display.
.
to switch the ap-
on the display.
.
on the display.
Advertisement
Table of Contents
