Hoover H-DISH 500 HDIN 4D620PB/E Manual page 104

Enabling or disabling DEMO MODE
(be used exclusively in stores)
Enabling
The dishwasher must ALWAYS be off
before you start this procedure.
1. Open the door.
2. Turn on the appliance using the
ON/OFF button.
3. Press the "PROGRAMME SELECTION"
and "DELAY START" buttons together
for 5 seconds.
4. "DEMO MODE ON" will appear on the
display.
5. If no button is pressed for 30 seconds,
the programme will start, simulating the
start of a wash programme.
The PROGRAMME
OPTIONS/ DELAY START options are
enabled, and by pressing these buttons
you can simulate
functioning without starting a wash.
SELECTION./
the product's
104
Disabling "Demo mode"
WARNING
Once installed,
works correctly but the wash cycle
does not start upon pressing the
Start button, "Demo mode" may not
have been disabled.
The dishwasher must ALWAYS be off
before you start this procedure.
1. Open the door.
2. Turn on the appliance using the On/Off
button.
3. Press the "PROGRAMME SELECTION"
and "DELAY START" buttons together
for 5 seconds.
4. "DEMO MODE OFF" will appear on the
display.
5. Switch off the appliance.
if the appliance