Hoover HDIN 2L360PB Manual page 95

l
Press the "DELAY START" button to
activate the MEMO FUNCTION (refer to
the appropriate chapter in the instruction
booklet for information on how to turn it
on and off).
"AUTOMATIC" programmes
(only on some models)
The dishwasher is equipped with a dirt sensor,
capable of analysing water murkiness during all
"AUTOMATIC" programme phases (see
programme legend). Thanks to this device,
the wash cycle parameters are automatically
adapted to the real quantity of dirt on dishes.
This is because water murkiness is linked to the
quantity of dirt on dishes. Thus, excellent
washing results are
optimising water and energy consumption.
"IMPULSE" programmes
(only on some models)
The "IMPULSE" programmes use an
impulse washing technology, which reduces
consumption and noise, and improves
performance.
The "intermittent" working of the
washing pump
considered a malfunction; it is a
characteristic of impulse washing,
and therefore should be considered a
normal feature of the programme.
ADDISH (possibility of adding
dishes after the programme has
started)
When the programme starts, you should
only open the door and add more dishes
when the ADDISH indicator light is switched
on. The appliance will stop automatically and
the time remaining to the end of the cycle will
flash on the display. Close the door, without
pressing any buttons.
The cycle will start from where it left off. When
the relating indicator light switches off, it is no
longer advisable to add further dishes.
guaranteed while
is NOT to be
Open the door slowly and carefully, to
avoid getting wet with splashes of
washing water.
Adding dishes
indicator light has switched off is
strongly discouraged as this could
affect the wash performance.
WARNING
If you open the door during the drying
cycle, an intermittent audio signal
advises you that the drying cycle has
not yet finished.
Programme interruption
Opening the door when a programme is
running is not recommended especially
during the main wash and final hot rinse
phases. However, if the door is opened
while a programme is running (for example,
to add dishes)
automatically. Close the door, without
pressing any buttons. The cycle will start
from where it left off.
WARNING:
If you open the door during the drying
cycle, an intermittent audio signal
advises you that the drying cycle has
not yet finished.
Changing a running programme.
Proceed as follows to change or cancel a
running program:
l
Open the door.
l
Hold the "START/RESET" button down
for at least 3 seconds.
l
Some audible signals will sound and the
programme indicator lights will turn on
and off individually and sequentially.
95
after the ADDISH
the machine stops