Detector; Auxiliary Heated Zone - Shimadzu GC-2010 Plus Instruction Manual

OCI/PTV-2010
Injection unit
Range of temperature
Program ramps
Temperature setting
Program rate
Heating speed
Cooling speed
Cooling
1.2.4

Detector

Overheat protection
Time constant
○ Hydrogen flame ionization detector (FID)
Range of temperature
Minimum detection
Dynamic range
Jet material
○ Thermal conductivity detector (TCD)
Amplifier
Power
Range of temperature
Sensitivity
Dynamic range
○ Electron capture detector (ECD)
Radiation source
Range of temperature
Minimum detection
Dynamic range
○ Flame photometric detector (FPD)
Range of temperature
Minimum detection
Dynamic range
○ Flame thermionic detector (FTD)
Range of temperature
Minimum detection
Dynamic range
1.2.5

Auxiliary heated zone

AUX3 to AUX5
: On-column/PTV injection
: Room temperature + 5 °C to 450 °C (column oven temperature: 50 °C)
: 7 ramps
: 0.1 °C increments
: Up to 250 °C/min
: Within 3 minutes heating from 50 °C to 450 °C
: Approximately 8 minutes cooling from 450 °C to 50 °C (column
oven temperature: 50 °C)
: A special cooling fan is used.
: Programmable up to 470 °C
: 4 ms to 2 s selectable
: Up to 450 °C, 0.1 °C increments
: 1.5 pg C/s
: 10
7
: Fused quartz
: With differential type filament protective circuit, tungsten
rhenium filament, dual-element configuration
: Constant current
: Up to 400 °C
: 20,000 mV ・ ml/mg
: 10 5
: Ni 370MBq
63
: Up to 350 °C
: 6 fg/s
: 10
4
: Up to 350 °C
: P: 55 fgP/s, S: 3 pgS/s
: P: 10 , S: 10
4 3
: Up to 450 °C
: N: 0.1 pgN/s, P: 0.03 pgP/s
: 10
3
: Available (optional)
1 Overview
1.2 Specifications
GC-2010 Plus
3