Table of Contents
Advertisement
Rear Panel
Rear Panel
The following figure shows the rear panel of the Secure Web Appliance S196 and S396. See
on page 15
Figure 10: Secure Web Appliance S196 and S396 Rear Panel
1
3
5
7
9
11
13
15
Cisco Secure Web Appliance S196, S396, S696, and S696F Hardware Installation Guide
12
for a description of the LEDs.
Proxy port 1 (P1)
Connects to the network for both incoming and
outgoing traffic.
Traffic monitor port 1 (T1)
Use for Duplex Ethernet tap; one cable for all
incoming and outgoing traffic.
1050-W AC power supply (PSU 2)
Threaded holes for dual-hole grounding lug
Use is optional. The supported AC power supplies
have internal grounding, so no additional chassis
grounding is required.
USB 3.0 Type A (USB 2)
Management interface (M1)
Restricted to management use only
RPC port (RPC)
Used for remote power cycling
VGA video port (DB-15 connector)
Not supported
2
Proxy port 2 (P2)
When P1 and P2 are both enabled, you must
connect P1 to the internal network and P2 to the
internet.
Note
You can connect P1 and P2 to an
L4 switch, WCCP router, or
network switch.
4
Traffic monitor port 2 (T2)
Use for Simplex Ethernet tap; one cable connected
to T1 for all packets going to the internet. and one
cable connected to T2 for all packets coming from
the internet.
6
1050-W AC power supply (PSU 1)
8
Unit identification button
10
USB 3.0 Type A (USB 1)
Management interface (M2)
12
Not in use
Serial console port (Console)
14
RJ-45 connector that directly connects a
management computer to the appliance.
—
Overview
Rear Panel LEDs,
Advertisement
Table of Contents
