Table of Contents
Advertisement
4. Troubleshooting
4-4-3 White Balance - Adjustment
ADC/WB
White Balance
4-5. Servicing Information
4-5-1 Upgrading the Software
Samsung may offer upgrades for TV's firmware in the future. Please contact the Samsung call center at 1-800-
SAMSUNG (726-7864) to receive information about downloading upgrades and using a USB drive. Upgrades will
be possible by connecting a USB drive to the USB port located on your TV.
1.
Insert a USB drive containing the firmware upgrade
into the Wiselink Pro port on the side of the TV.
2.
If pop up is showed, press the exit or or press the No
button. (If you press Yes button, display is changed to
Wiselink Pro Menu )
3.
Press the MENU button to display the menu.
Press the ▲ or ▼ button to select "Setup", then press
the ENTER button.
4.
Press the ▲ or ▼ button to select "SW Upgrade", then
press the ENTER button.
5.
Press the ENTER button.
The message "Scanning for USB... It may take up to 30
seconds." is displayed.
6.
The message "Upgrade version XXXX to version XXXX?
The system will be reset after upgrade." is displayed.
Press the ◄ or ► to select the "OK", then press the
ENTER button.
Please be careful to not disconnect the power or remove
the USB drive while upgrades are being applied. The TV
will turn off and turn on automatically after completing
the firmware upgrade. Please check the firmware version
after the upgrades are complete. When software is
upgraded, video and audio settings you have made will
return to their default (factory) settings.
We recommend you write down your settings so that you
can easily reset them after the upgrade.
4-34
(low light)
Sub Bright
R offset
G offset
B offset
(W/B adjustment Condition refer next page)
(hight light)
Sub Contrast
R gain
G gain
B gain
Advertisement
Table of Contents
