Table of Contents
Advertisement
TROUBLESHOOTING
28
Symptoms
Child Lock LED On
CHILD LOCK FUNCTION
Rinse+Spin LED Blinks
DRAIN FEATURE
Door Lock and Child
Lock LEDs Blink
DOOR ERROR
Door Lock LED Blinks
DOOR LOCK ERROR
Rinse+ and Cold LEDs
Blink
FOREIGN OBJECTS
ERROR
Tub Clean LED Blinks
TUB CLEAN ALARM
Rinse+Spin and Warm
LEDs Blink
TEMPERATURE SENSOR
ERROR
Rinse+Spin and Cold
LEDs Blink
OVERFLOW ERROR
Hot LED Blinks
PRESSURE SENSOR
ERROR
Deep Fill and Cold LEDs
Blink
MOTOR LOCKED ERROR
It is not an error. This prevents children from changing cycles or
operating the appliance.
• Turn off the Child Lock function in the control panel.
The appliance is paused during a cycle for a few minutes.
• The cycle will be cancelled and any water remaining in the drum will be
drained.
The door is not closed properly.
• Close the door completely. If the error code is still displayed, call for
service.
The door is opened while the washing machine is operating.
• Press Start/Pause to cancel the door error. Press Start/Pause again to
start the washing programme.
Door is not locked properly.
• Check nothing is caught under the door, including shipping materials or
clothing.
• Close the door completely. If the error code is still displayed, call for
service.
Foreign objects, such as coins, pins, clips, etc.,are caught between the
pulsator and the inner drum.
• Turn off the appliance and then press the POWER button. Select the Spin
Only programme to drain and spin the laundry. When the cycle is
complete, remove the clothes and then find and remove any objects
caught in the pulsator gap.
The programme has run more than 30 times.
• Run the Tub Clean function.
Control error.
• Unplug the appliance and wait 60 seconds. Reconnect power and try
again.
• If the error code is still displayed, call for service.
Water overfills due to the faulty water valve.
• Close the water taps, unplug the appliance, and call for service.
The water level sensor is not working correctly.
• Close the water taps, unplug the appliance, and call for service.
A motor error has occurred.
• Allow the appliance to stand for 30 minutes and then restart the cycle.
• If the error code is still displayed, call for service.
Possible Cause & Solution
Advertisement
Table of Contents
