Cuisinart PG-25144C Quick Reference Manual

TROUBLESHOOTING GUIDE

Problem: Solution:
Brewer does not have power. Plug brewer into an independent outlet.
Make sure the brewer is securely plugged in.
Plug into a different outlet.
Confirm the power has been turned on and the LCD is
illuminated.
Brewer will not brew/doesn't Every once in a while an air bubble may get trapped in
brew a full cup. the water path. Lift off the reservoir, then put it back into
place.
Turn off and unplug the brewer for 30 seconds or more.
When you plug the brewer back in, be sure to turn the
power back on.
After placing the K-Cup
the handle is pushed down securely and the LCD control
panel reads READY. The
Water, and Rinse buttons will be illuminated. Then press
any of the lit buttons.
Make sure the water reservoir is properly in place, and
perform a Rinse cycle.
The exit needle may be clogged (refer to "Cleaning &
Maintenance" page 18).
Clean the K-Cup
Maintenance" page 18).
The time is not displayed on You must set the clock (refer to page 15) in order for the
the LCD control panel. time to be displayed on the LCD.
If power is interrupted to the brewer, you will need to
reset the clock (refer to page 15).
Brewer shuts off Make sure the AUTO OFF and the On/Off time features
or turns on automatically. have not been set. To do this, press the Menu button and
scroll through the programming options. OFF should be
displayed for AUTO OFF timer and On/Off. If OFF is not
displayed, you must reset (refer to page 15).
The blue light in the water This indicates the water level in the reservoir is low and
reservoir is flashing. water must be added (refer to page 14) in order to brew
a full cup.
If sufficient water is in the reservoir, make sure the
reservoir is properly seated in the base.
Chlorine or mineral taste in Consider using bottled water, filtered water or the
coffee. Cuisinart Charcoal Water Filter.
Coffee is too weak or watery. Reduce the brew size for a stronger-tasting cup of coffee
(refer to "Programming Your Brew Size" on page 18).
Try an Extra Bold K-Cup
in each portion pack.
For more helpful hints see instruction booklet
PG-25144C
® in the K-Cup ® Holder, make sure
and buttons, Brew, Hot
® brewing chamber (refer to "Cleaning &
® . It has 30% more ground coffee
QUICK REFERENCE GUIDE
Single Serve Brewing System
SETUP
1.
Plug the brewer into
a grounded outlet.
Make sure to remove
all packing tape, stickers and
polybags from the brewer.
Lift reservoir straight up and
away from the brewer and wash
reservoir with water to the max
2. Follow directions carefully to
maximize flavor and performance.
tap water – soak for 15 minutes.
pull toward you to open.
closed. Be careful – improper placement
3.
water through lower portion of
the water reservoir, pushing it down to
Setup instructions continued inside
Water
Reservoir
Lid
Charcoal
Water Filter
Water
Reservoir