Ryobi PBLLB01 Operator's Manual page 10

One+ 18v blower
Table of Contents

Advertisement

Available languages

Available languages

To remove:
� Depress the latches on the battery pack and remove
from the blower.
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be in the OFF position when not in
use. Remove battery pack when transporting or carrying
blower to avoid accidental starting, which could result in
serious injury.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
STARTING/STOPPING THE BLOWER
See Figure 4.
� To start the blower, depress the switch trigger.
� To stop the blower, release the switch trigger.
MODE SETTINGS
See Figure 4.
The product has two modes to accommodate your needs.
� Press the MODE button to switch to MAX POWER mode,
for maximum power.
� Press the MODE button to switch to MAX RUN TIME
mode, for a longer run time.
USING CRUISE CONTROL
See Figure 4.
The cruise control can be used to operate the blower without
holding the switch trigger.
To engage the cruise control:
� Depress the switch trigger and stop at the desired speed.
� Push the cruise control lever down.
� Release switch trigger.
OPERATION
� To release the cruise control, pull the cruise control lever
all the way up.
OPERATING THE BLOWER
See Figure 5.
� To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the center
of a pile.
� To reduce sound levels, limit the number of pieces of
equipment used at any one time.
� Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when water
is available.
� Conserve water by using power blowers instead of hoses
for many lawn and garden applications, including areas
such as gutters, screens, patios, grills, porches, and
gardens.
� Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
� After using blowers or other equipment, CLEAN UP!
Dispose of debris properly.
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be in the OFF position when not in
use or carrying at your side.
8 — English

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pbllb01b

Table of Contents