Table of Contents
Advertisement
•
Secure the cable with the cable ties. Trim excess
ends of cable ties. See Figure 6B.
Use These Holes
•
Secure wheel to deck with one larger cupped
washer on the inside of the deck (cupped side
against the deck) and hex nut. Tighten securely.
•
Assemble the other wheels in the same manner.
Remove the blocks.
Attaching The Starter Rope
(Hardware C)
•
The starter rope is inside the top of the engine. With
the spark plug wire disconnected and grounded,
depress the blade control handle and pull the rope
out of the engine.
•
Place the rope guide around the starter rope, so the
opening in the rope guide is toward the front of the
mower as shown. Insert the rope guide into the right
side of the handle, and secure with hex lock nut.
See Figure 8.
Final Assembly Of Mower
Figure 7
The three holes provide three cutting heights for your
mower. Use the same hole location for all four wheels
when assembling. If wheels are to be assembled in the
lowest cutting position (highest hole in the deck), refer
to the note below.
If your mower has two sets of holes (see Figure 7), the
front wheels must be assembled in one of the three
holes nearest the front of the deck. The rear wheels
must be assembled in one of the three holes nearest
the rear of the deck. To assemble the wheels: (See
Figure 7).
•
Block up the mower securely.
•
Place axle bolt through wheel. (Hub side of wheel
must face deck.)
•
Place one smaller cupped washer on axle bolt, with
the cupped side of washer toward the deck (away
from wheel).
NOTE: If the lowest cutting position (highest hole in the
deck) is used, it is necessary to place the larger washer
on the outside of the deck and the smaller washer on
the inside.
•
The chute deflector on your mower is held in an
upright position by a retainer for shipping purposes
only. This shipping retainer must be removed and
discarded before the mower is put into operation.
See Figure 9. To remove the shipping chute
retainer, move the spring-loaded chute toward the
engine by pushing above the retainer. Remove the
retainer arid carefully lower the chute into operating
position. Tighten bolts securely.
10
Advertisement
Table of Contents
